The tariff classification of nonalloy low carbon steel tubing from Italy
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated October 14, 2026, you requested a tariff classification ruling on behalf of your client, Webco Industries. The product under consideration is identified as ASTM A179 U-bend steel tubing for use in boilers, condensers, heat exchangers, and feedwater heaters. In your submission, you indicate the U-bend tubing, is made from seamless cold-drawn low carbon steel tubing and is bent around a die to achieve the proper bend radius.
The tubing is ¾ inch (19.05 mm) in outside diameter with a total length ranging from of 43 feet 4 and 23/32 inches to 48 feet 6 and 29/32 inches depending on the radius of the curve in the bend.
General Rule of Interpretation (GRI) 1, Harmonized Tariff Schedule of the United States (HTSUS), states in part that for legal purposes, classification shall be determined according to the terms of the headings, any relative section or chapter notes and, unless otherwise required, according to the remaining GRI’s taken in order. In understanding the language of the HTSUS, the Harmonized Commodity Description and Coding System Explanatory Notes may be utilized.
The Explanatory Notes (ENs), although not dispositive nor legally binding, provide a commentary on the scope of each heading of the HTSUS, and are the official interpretation of the Harmonized System at the international level. See T.D. 89-80, 54 Fed. Reg. 35127, 35128 (August 23, 1989).
The ENs to heading 7304 state that “products of this heading include, in particular, line pipes of a kind used for oil or gas, casing, tubing and drill pipes of a kind used in drilling for oil or gas, tubes and pipes suitable for use in boilers, superheaters, heat exchangers, condensers, refining furnaces, feedwater heaters for power stations, galvanised or black tubes (socalled gas tubes) for high or medium pressure steam, or gas or water distribution in buildings, as well as tubes for water or gas street distribution mains.” General EN 1 to Chapter 73 defines pipes and tubes as follows and states that they may be bent: Concentric hollow products, of uniform crosssection with only one enclosed void along their whole length, having their inner and outer surfaces of the same form.
Steel tubes are mainly of circular, oval, rectangular (including square) crosssections but in addition may include equilateral triangular and other regular convex polygonal crosssections. Products of crosssection other than circular, with rounded corners along their whole length, and tubes with upset ends, are also to be considered as tubes. They may be polished, coated, bent (including coiled tubing), threaded and coupled or not, drilled, waisted, expanded, cone shaped or fitted with flanges, collars or rings.
The applicable subheading for the ASTM A179 U-bend steel tubing will be 7304.31.6010, HTSUS, which provides for tubes, pipes and hollow profiles, seamless, of iron (other than cast iron) or steel, other, of circular cross section, of iron or nonalloy steel: cold-drawn or cold-rolled (cold-reduced), other, suitable for use in boilers, superheaters, heat exchangers, condensers, refining furnaces, and feedwater heaters. The general rate of duty will be free.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N366027).