The tariff classification of a mechanical screw jack from Belgium
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the pipe rack jack will be 8425.49.0000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Pulley tackle and hoists other than skip hoists; winches and capstans; jacks: Jacks; hoists of a kind used for raising vehicles: Other.” The general rate of duty will be free.
Ruling text
In your letter dated October 16, 2026, you requested a tariff classification ruling. The merchandise under consideration is referred to as a pipe rack jack and is described as a portable, manually operated mechanical jack for lifting pipes. It consists of a rigid rectangular aluminum body equipped with two clamping jaws that are used to attach the jack to a beam. Each end of the body features a threaded steel spindle that extends vertically, a spindle nut, and a stainless-steel V-shaped support.
The pipe rack jack is used to lift a pipe in a pipe rack during inspections or when pipe supports require replacement or refurbishment. Once mounted to the beam, the operator manually turns the spindle nuts to extend the spindles. The pipe rack jack can lift a load of up to 5,500 pounds through a maximum distance of 18.5 inches. Its overall dimensions are 36 inches in length, 11 inches in width, and 4.5 inches in height.
The applicable subheading for the pipe rack jack will be 8425.49.0000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Pulley tackle and hoists other than skip hoists; winches and capstans; jacks: Jacks; hoists of a kind used for raising vehicles: Other.” The general rate of duty will be free. Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/.
This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
For further information to assist with the importation process, please refer to the frequently updated Cargo Systems Messaging Service (CSMS) messages at https://www.cbp.gov/trade/automated/cargo-systems-messaging-service and the Trade Remedies page at https://www.cbp.gov/trade/programs-administration/trade-remedies. The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request.
This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1). This section states that a ruling letter is issued on the assumption that all of the information furnished in the ruling letter, whether directly, by reference, or by implication, is accurate and complete in every material respect.
In the event that the facts are modified in any way, or if the goods do not conform to these facts at time of importation, you should bring this to the attention of U.S. Customs and Border Protection (CBP) and submit a request for a new ruling in accordance with 19 CFR 177.2. Additionally, we note that the material facts described in the foregoing ruling may be subject to periodic verification by CBP.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N366155).