The tariff classification of polytetrafluoroethylene rods in a polypropylene container from China
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated November 5, 2024, you requested a tariff classification ruling. The product under consideration consists of 50 rods of extruded Polytetrafluoroethylene (PTFE) in a molded polypropylene container. The extruded PTFE rods measure 2 mm in diameter and are 60 mm in length. Documentation indicates that the product will be used in a dental office setting. The PTFE will be measured, cut and sterilized by dental practitioners for use during dental implant procedures.
The container simply holds the PTFE until use by the dental practitioner. For this reason, this office has determined that the PTFE provides the essential character of this product. You indicate that the PTFE is extruded from 100% virgin PTFE and cut into rods in the United States. The packaging manufacturer in China fabricates the container from polypropylene. The PTFE rods are shipped from the United States to the Chinese manufacturer for incorporation into the container.
The rods are packaged in increments of 50 rods per container and shipped back to the United States. You indicate that the rods, of U.S. Origin PTFE, are provided free of charge to the Chinese manufacturer for packaging into the containers.
Subheading 9802.00.80, Harmonized Tariff Schedule of the United States, (HTSUS), provides a partial duty exemption for: articles assembled abroad in whole or in part of fabricated components, the product of the United States, which (a) were exported in condition ready for assembly without further fabrication, (b) have not lost their physical identity in such articles by change in form, shape, or otherwise, and (c) have not been advanced in value or improved in condition abroad except by being assembled and except by operations incidental to the assembly process, such as cleaning, lubricating, and painting.
All three requirements of subheading 9802.00.80, HTSUS, must be satisfied before a component may receive a duty allowance. An article entered under this tariff provision is subject to duty upon the full cost or value of the imported assembled article, less the cost or value of the U.S. components assembled therein, upon compliance with the documentary requirements of section 10.24, Customs Regulations (19 CFR 10.24). The PTFE is extruded and cut into rods in the United States from 100% virgin PTFE.
The PTFE is then exported to China in condition ready for packaging into the polypropylene dispensers without further fabrication.
The applicable subheading for the extruded polytetrafluoroethylene rods in a polypropylene container will be 3916.90.5000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for monofilament of which any cross-sectional dimension exceeds 1 mm, rods, sticks and profile shapes, whether or not surface-worked but not otherwise worked, of plastics: of other plastics: other: other: The general rate of duty will be 5.8 percent ad valorem.
The U.S. origin spool rods of PTFE, packaged in the container, meet all three requirements of subheading 9802.00.80, HTSUS and is entitled to the duty exemption under subheading 9802.00.80, HTSUS. This provision allows for duty free entry of U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N343779).