The tariff classification of a flexible laminated aluminum foil-plastic product from France
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the flexible aluminum foil-plastic product will be 7607.20.1000, HTSUS, which provides for aluminum foil (whether or not printed, or backed with paper, paperboard, plastics or similar backing materials) of a thickness (excluding any backing) not exceeding 0.2 mm: backed: covered or decorated with a character, design, fancy effect or pattern.
- The rate of duty will be 3.7 percent ad valorem.
Ruling text
In your letter dated August 13, 2025, you requested a tariff classification ruling. The item under consideration is identified as a flexible, laminated plastic product (F12-011) that is used in the manufacture of unit-dose cosmetic sampling. It is imported in roll stock format, printed with customer-specific artwork and ready to be converted into finished samples with the appropriate cosmetic products added. Samples were received and will by retained by this office.
According to your submission, the product is comprised of three layers of non-cellular plastic and one layer of aluminum foil with adhesive layers between each. The product is non-rigid and not reinforced by paper.
The total thickness of the product is 114 microns (0.114 mm) with the first layer, polyethylene terephthalate (PET), measuring 12 microns (0.012 mm) in thickness, the second layer, aluminum foil, measuring 9 microns (0.009 mm) in thickness, the third layer, also PET, measuring 12 microns (0.012 mm), and the final layer, polyethylene (PE), measuring 75 microns (0.075 mm) in thickness.
The first layer of PET faces outward with the printed artwork and protects the samples from abrasion, scuffing and environmental exposure. The aluminum foil layer provides the barrier properties to reduce oxygen, moisture, and aroma transmission. The second layer of PET protects the aluminum foil layer by providing additional strength, dimensional stability, and protection during conversion and use. The final layer, PE, is the thickest layer.
It acts as a sealant and forms the inner surface that comes into contact with the samples. You suggest classification of F12-011 in 3921.90.4090, Harmonized Tariff Schedule of the United States (HTSUS). We disagree. The principal use of this product is to serve as sealed sachets for cosmetic samples. To function as a container the material must have the ability to protect and preserve the contents.
While the plastic layers provide reinforcement and a printable surface, it is the aluminum layer that provides the “barrier properties to reduce oxygen, moisture, and aroma transmission.” Therefore, this material is excluded from classification as a plastic sheet in 3921.90.4090, HTSUS. The aluminum foil layer provides a necessary barrier to oxygen, moisture, and aroma transmission.
Once the plastic layers are merged with the aluminum foil, the aluminum foil still provides that necessary barrier and remains a critical component of the product. The product’s ability to function as a container for cosmetic products is dependent on its ability to prevent oxygen, moisture, and aroma transmission from occurring. Plastics also contribute to the barrier function, but in a supporting/backing capacity only.
As stated in your submission, the second layer of PET protects the aluminum foil by providing additional strength, dimensional stability, and protection during conversion. In other words, the plastic layers facilitate and enable the aluminum foil to provide the critical barrier property.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352361).