The tariff classification of stamping dies from South Korea
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The general rate of duty will be 5.7 percent ad valorem.
- The general rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated October 20, 2025, you requested a tariff classification ruling. The items under consideration are five dies that operate individually within a production line that produces automotive body components from steel or aluminum sheets. Each die consists of an upper and lower component and is made primarily of cast iron. The dies are mounted on the upper and lower sections of press equipment that performs a repetitive vertical motion.
Pressure from both the upper and lower component is then applied to the steel or aluminum sheets. You have stated that because of the large size of the dies, each complete die (i.e., the upper and lower component) will be imported separately. The dies are identified and described as follows: Drawing Die (OP10) – Designed to form blank metal sheets into pre-defined automotive body panel shapes by applying pressure to both upper and lower surfaces.
Trimming Die (OP20) – Used to trim excess material and pierce mounting holes for automotive body part assembly. Flanging Die (OP30) – Used to bend designated sections (flanging) for automotive body panel production. Restriking Die (OP40) – Re-forms areas requiring further shaping (restriking) for automotive body panel production. Hemming Die (HEM) – Used to bend and press the edges of outer body panels for accurate joining with inner panels.
You suggested in your submission that the entire line of dies should be classified as a set within subheading 8207.30.6032, Harmonized Tariff Schedule of the United States (HTSUS), which provides for stamping dies not suitable for cutting metal. As precedent to your proposed classification, you cite New York Ruling N295035, dated March 30, 2018. We note that each individual die in that ruling was capable of forming metal at the time of importation. It should also be noted that the dies were not classified as a set.
In order to classify a set for tariff classification purposes, all the items must be present at the time of importation. In your importation scenario, each die will be imported separately. Therefore, in accordance with General Rule of Interpretation 1 of the HTSUS, classification will be determined by the function and condition of each individual die at the time of importation.
The applicable subheading for the Trimming Die (OP20) will be will be 8207.30.3020, HTSUS, which provides for interchangeable tools for handtools, whether or not power operated, or for machine-tools (for example, for pressing, stamping, punching, tapping, threading, drilling, boring, broaching, milling, turning or screwdriving), including dies for drawing or extruding metal, and rock drilling or earth boring tools; base metal parts thereof : tools for pressing, stamping or punching, and parts thereof: suitable for cutting metal, and parts thereof…tools.
The general rate of duty will be 5.7 percent ad valorem.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N355054).