The tariff classification of a spring from the Philippines
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the Spring, Arm (Item 314-00003-000.B4) will be 7320.20.5020, HTSUS, which provides for Springs and leaves for springs, of iron or steel: Helical Springs: Other: Helical springs, of wire having a cross-sectional dimension of less than 5.1 mm: Other.
- The general rate of duty will be 3.9 percent ad valorem.
Ruling text
In your letter dated November 16, 2025, you requested a tariff classification ruling regarding a spring from the Philippines. Product information was submitted with your request. The spring under consideration is referred to as “Spring, Arm” (Item 314-00003-000.B4). It is described as a component that will be installed into the “Sierra” model of noise canceling aviation headset. Specifically, the high carbon steel spring will be assembled into the inside of the headset’s headband assembly.
You state that the spring allows the headband to flex repeatedly without losing shape or clamping force over time. In addition, it allows for adjustability, absorbs and dampens vibrations, and acts as a binder which supports other components within the headband assembly such as padding and wiring. Based on the submitted documents, the spring at issue is a helical spring.
At both ends, the wire extends laterally from the main coil and curves inward at approximately 90 degrees to form two “arms.” The submitted pictures show that the arms allow the spring to connect to and provide tension to surrounding components. As noted on the submitted drawing, the wire measures 1.91 millimeters (mm) in cross sectional diameter. Additionally, the coil has an outside diameter of approximately 10 mm and measures 22.6 mm in length.
Classification of merchandise under the Harmonized Tariff Schedule of the United States (HTSUS) is governed by the General Rules of Interpretation (GRIs). GRI 1 provides that classification is determined first in accordance with the terms of the headings of the tariff and any relative section or chapter notes.
Note 1(g) to Section XVI and Note 2(b) to Section XVII exclude “Parts of general use as defined in note 2 to section XV, of base metal (section XV) or similar goods of plastics (chapter 39).” Note 2(b) to Section XV lists springs and leaves for springs, of base metal, as parts of general use.
The applicable subheading for the Spring, Arm (Item 314-00003-000.B4) will be 7320.20.5020, HTSUS, which provides for Springs and leaves for springs, of iron or steel: Helical Springs: Other: Helical springs, of wire having a cross-sectional dimension of less than 5.1 mm: Other. The general rate of duty will be 3.9 percent ad valorem. The duties cited above are current as of this ruling’s issuance. Duty rates are provided for your convenience and are subject to change.
The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/. This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N356064).