The tariff classification of multilayer wood flooring from Indonesia
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The rate of duty will be 8 percent ad valorem.
Ruling text
In your letter, dated September 8, 2025, you requested a binding tariff classification ruling on multilayer wood flooring. Product information and samples were submitted for our review. The products under consideration are multilayer wood flooring panels in multiple shapes, including rectangle, hexagon, and rhombus. For each, the face ply is a single, solid veneer, and is not constructed of multiple shapes or strips laminated together. The flooring panels are constructed of three wood plies.
The panel samples measure approximately 12mm in thickness. The face ply of each panel measures 3mm in thickness and consists of white oak, a non-coniferous wood. The core measures just over 6mm in thickness and consists of pine lumber blocks. The back layer will measure 3mm in thickness and consists of rubberwood ( Hevea spp., a tropical wood). The grain of the center ply runs at a 90-degree angle to that of the face and back plies. The panels are tongued and grooved along their edges and ends.
The face is covered with a clear material that does not obscure the grain. In understanding the language of the Harmonized Tariff Schedule of the United States (HTSUS), the Explanatory Notes to the Harmonized System (ENs) may be utilized. The ENs, although not dispositive nor legally binding, provide a commentary on the scope of each heading of the HTSUS, and are the official interpretation of the Harmonized System at the international level.
See T.D. 89-80, 54 Fed. Reg. 35127, 35128 (August 23, 1989). “Plywood” is defined in the ENs for heading 4412, HTSUS: a panel “consisting of three or more sheets of wood glued and pressed one on the other and generally disposed so that the grains of successive layers are at an angle.” This definition describes the instant panels.
The ENs also describe “blockboard” as panels “in which the core is thick and composed of blocks, laths or battens of wood glued together and surfaced with the outer plies.” This also describes the instant panels. Both plywood and blockboard are specifically provided for in heading 4412 of the HTSUS.
Note 4 to Chapter 44 provides that: Products of heading 4410, 4411 or 4412 may be worked to form the shapes provided for in respect of the articles of heading 4409, curved, corrugated, perforated, cut or formed to shapes other than square or rectangular or submitted to any other operation provided it does not give them the character of articles of other headings.
Because the flooring panels do not have the character of goods of headings other than 4412, the hexagonal and rhomboid shapes do not impact classification. Therefore, each of the panels is classifiable in heading 4412, HTSUS.
The applicable subheading for the 3-ply multilayer wood flooring panels with a 3mm-thick face ply of white oak and a 3mm-thick back ply of rubberwood will be 4412.51.3105, HTSUS, which provides for Plywood, veneered panels and similar laminated wood: Blockboard, laminboard and battenboard: With at least one outer ply of tropical wood: Plywood: Not surface covered, or surface covered with a clear or transparent material which does not obscure the grain, texture or markings of the face ply: Other: Wood flooring.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N353413).